1962 40 HP Johnson outboard driveshaft seems to be stuck to power head. How do I get them apart to replace Impeller and seals?

perhaps you have taken the examination address from the housing and disconnected the apparatus change shaft such that it simply slides completely  !!!!!!!!!!     The dish is all about half-way amongst the cavitation dish together with underside for the motor block. The dish is all about 2 ins very long and held in position by 2 screws. As soon as eliminated you will observe a brass coupler with two screws . Undo underneath screw and pop it apart. A warning place the change backwards so when you reassemble ensure you have actually bottom end up in reverse when you attend reassemble. Don’t inexpensive out and merely change the impeller, purchase the entire liquid pump system and it’ll endure you quite a while.

Maybe you have taken the examination address from the housing and disconnected the apparatus change shaft such that it simply slides completely  !!!!!!!!!!     The dish is all about half-way amongst the cavitation dish together with underside for the motor block. The dish is all about 2 ins very long and held in position by 2 screws. As soon as eliminated you will observe a brass coupler with two screws . Undo underneath screw and pop it apart. A warning place the change backwards so when you reassemble ensure you have actually bottom end up in reverse when you attend reassemble. Don’t inexpensive out and merely change the impeller, purchase the entire liquid pump system and it’ll endure you quite a while.

Drench in PB-Blaster for just two times.

Solidly secure the ability check out a workbench or a great trestle and make use of a wood mallet going to the low product securely in numerous instructions. 
If it fails take to a little bit of temperature: guard either the low product or even the energy mind making use of damp towels and employ a tresses dryer on hot to heat up within the uncovered material near the joint. The standard hot-air firearm may also just work at the possibility of paint harm. 
When the mind or even the reduced product being heated up take to various razor-sharp taps once again with a wood mallet or make use of the standard hammer with a wood block. Avoid using a metal hammer to material castings straight. 
Penetrating oil like Plus petrol will also help, or usage diesel/paraffin. Don’t waste WD-40 about it as despite exactly what the might promises it is an unhealthy acute oil and a rubbish lubricant. The main function of that things can be as a Water Dispersant (hence WD).

Leave a Comment